GLOBAL STEEL COMPANY | 24/7 AFTER SALES SUPPORT
Special Steel Includes Cold Work Steel, Hot Work Steel, Plastic Mould Steel, High Speed Steel, High Strength Steel, Abrasion Resistant Steel. These tool materials adhere to great quality demands of steel like temper, strength, toughness, resistance to tempering, hardening capacity, dimensional stability etc. The range of Tool Steel in our store includes products from renowned manufacturers.
Pre-hardened Martensitic stainless chromium steel with excellent corrosion resistance, higher than similar Cr grades (i.e. WW.NR. 1.2083) characterized by special alloying with the addition of Sulphur.
WW.NR. 1.2085 is used for core parts and mould bases of corrosion resistance plastic moulds or where equipment needs to be made with excellent workability and excellent corrosion resistance.
DIN | W.Nr | AFNOR | AISI/SAE | JIS |
---|---|---|---|---|
- | 1.2085 | ~Z33CS16 | ~442+S | - |
C | Si | Mn | P (max) | S (max) | Cr | Mo | Ni |
---|---|---|---|---|---|---|---|
0.28-0.38 | <1.00 | <1.40 | 0.030 | 0.05-0.10 | 15.00-17.00 | - | - |
EAF – LF – VD - Forging – Heat treatment QT
In according to standard EN10228-3 Class 4 and standard SEP 1921 Class E/e
WW.NR. 1.2085 is delivered in quenched and tempered condition, with hardness range 280 - 325 HB (29 – 35 HRC).
Thermal expansion coefficient (10-6/K) | 10.5 | 10.7 | 12 | 13.2 |
---|---|---|---|---|
Thermal conductivity (W/mk) | 22.2 | 22.7 | 21 | 24.5 |
Young modulus (Kn/mm2) | 215 | 211 | 203 | 180 |
Ac1 790 °C
Ac3 890 °C
Ms 190 °C
TREATMENT | TEMPERATURE | HOLDING TIME (HT) | COOLING | COMMENTS | |
---|---|---|---|---|---|
Annealing | Heat to 850 - 880 °C | Min. H.T. for 2 minute /mm | Air or furnace | In order to obtain hardness lower than 250 HB ( 24 HRC) to improve machinability | |
Stress relieving | Heat to 590 - 650 °C | Min. H.T. for 2 minute /mm | Air or furnace | To be carried out after machining, is recommended to eliminate the residual stresses induced by mechanical working | |
Hardening | Heat to 1000-1050°C | Min. H.T. for 1 minute /mm | Air or Polymer (depending of size) | - | |
Tempering | Heat to 550 – 610°C | Min. H.T. for 3 minute /mm | Air of furnace | To be carried out after hardening. 2nd Tempering must be performed to max 30°C below tempering temperature |