Sandeep Enterprises
W.NR. 1.2581
Special Steels

Special Steel Includes Cold Work Steel, Hot Work Steel, Plastic Mould Steel, High Speed Steel, High Strength Steel, Abrasion Resistant Steel. These tool materials adhere to great quality demands of steel like temper, strength, toughness, resistance to tempering, hardening capacity, dimensional stability etc. The range of Tool Steel in our store includes products from renowned manufacturers.

STEELW.NR. 1.2581

Characteristics

Tungsten-chrome–vanadium steel for hardening in oil and possibly in air with very good hardenability, very high firmness during the heat and resistance to the tempering, high resistance to the hot tempering and good toughness. Further the steel has a lower resistance to tearing of thermal fatigue and higher sensitivity to quick changes of temperature. The steel is not appropriate for tools cooled by water. It is well-workable during the heat and well-workable in the soft-annealed state.

Suitability

For tools for hot mechanical working such as highly stressed small pressing dies and die inserts especially for die forging of accurate products from the difficult-workable steels and copper alloys, thorns and jaws for forging presses, forgings for swaging, tools for production of rivets, nuts and screws, small extrusion dies (matrixes), thorns, pressing discs for extrusion of alloys of non-ferrous metals. Further the firm and movable parts of molds, core and other small and highly stressed parts of molds for pressure casting of copper alloys can be made from the steel. Tools for hot cutting such as highly stressed small shear blades, punching dies, small trimming dies.

Comparable standards
DINW.NrAFNORAISI/ASIMBSJIS
X30WCrV-9-31.2581~55NCD07-05H-21~224SKD5
Chemical composition (typical; in weight %)
CSiMnP (max)S (max)CrWV
0.25-0.350.10-0.400.15-0.450.0350.0352.50-3.208.00-9.000.30-0.50
Heat treatment of steel W.Nr. 1.2581
WayTemperature [°C]Procedure
Forging900-1150Cool slowly in air or better in dry ash or in other thermally-insulated material
Soft annealing750-800Warm few hours (according to the size of object), mostly four hours are enough and cool slowly in the furnace
Annealing to lower tension600-650Warm 1 to 2 hours and cool slowly in the furnace
Hardening1100-1150Cool in oil to the temperature of about 100 °C
1120-1170Cool bigger and difficult-shape tools in air or in thermal bath at the temperature of 500 – 550 °C
Tempering550-650Cool in air, the degree of tempering is set by hardness and toughness of instrument according to the tempering chart
Note

Chart of tempering values depending on the hardness:

°C100200300400500550600650700
HRC525150505152514837
N/mm2179017301690167017301790173015701170
Related Products